Conventional and cyclic unloading tests with different unloading rates were conducted to study the influences of unloading patterns and rates on the deformation characteristics and mechanical properties of tectonic coal. The results demonstrate that, under continuous unloading, a lower unloading rate promotes an increase in the circumferential strain but inhibits increases in axial strain.
The underground coal mining process is closely associated with frequent energy storage and consumption of coal mass with natural and induced fractures. Exploring the energy evolution characteristics of intact and fractured coal samples could be helpful for dynamic disaster control. In this study, laboratory true triaxial tests on the energy evolution characteristics of intact and fractured ...
Observing the whole unloading process, the unloading time is 133 s when the density of coal bulk is 1600 kg/m 3, the unloading time is s when the density is 1350 kg/m 3 and the unloading time is s when the density is 1100 kg/m 3, so the higher the particle density in the silo, the faster is the unloading speed.
In this process, the coal in a protected seam is subjected to cyclic loadingunloading effects, which significantly change the mechanical properties and seepage characteristics of the coal. Related research results show that gas has a significant influence on the mechanical properties and energy dissipation characteristics of coal [ 17, 18 ...
In the true triaxial cyclic mechanical experiment of coal, most of the total work done by the three principal stresses is accumulated in the coal with elastic potential energy (the elastic strain energy will be released in the unloading process of external force, approximately equal to the negative work done by the external force in the ...
Coalburst is a violent dynamic failure of coal during underground mining. It is of significance to study failure pattern as well as energy evolution and transition during coalbursts and how they are influenced by preconfinement. This paper presents unloadinginduced coalburst simulations using the distinct element method via a combined staticdynamic loadingunloading strategy.
In this study, coal fly ash was functionalized, using a simple onestep process (loading with Al3+ and sulfonation), to yield a solid acid catalyst (S/AlCFA) with strong acid sites. The catalyst was then used to produce furfural from xylose in a biphasic system (H2O(NaCl)/tetrahydrofuran). The furfural yield reached 82% at 180 °C60 min with catalyst/xylose ratio of : (w/w). With the ...
As the coal body has a hysteresis effect during the unloading process, it cannot be unloaded to 0 when unloading, and the minimum unloading level was set for the four kinds of samples; that is, after unloading to 2% σ c, the loading was performed until the sample was destabilized.
Both coal companies and Railways have envisaged to jointly ensure per day coal loading of 415 rakes of domestic coal and 30 rakes of imported coal to the power sector. 'In the current month ...
to start at full load. Coal handling system for modern power plants Tanjung Bin Power Plant with 3x700 MW, located in the southern state of Johor, Malaysia, is one of the largest coalfired power plants in Asia. The contract for the design, manufacture, supply, erection and commissioning of the coal handling system was awarded to TKF.
The residual strains has produced by the first loadingunloading of coal are 7 × 10 −5, × 10 −4, and × 10 −4, respectively. ... However, if the loadingunloading process was continued beyond this point, the residual strain reappeared. The occurrence of the nonresidual strain phenomenon was found to be directly related to the ...
The repeated mining causes the unloading and loading of the caved zone, so that the pore structures of caved zone change accordingly, and thus affect the permeability value, which controls the gas migration in the caved zone. The main factors affecting the permeability of the unloading process are different from those controlling it during loading.
Ship Cargo Handling, Loading, Unloading: A commercial ship is usually a link in a "trade route" between distant points. Goods flowing in the route must be transferred to and from the sea link; they must also be given care while aboard the ship, and in turn they must not be a hazard to the ship and its crew. Ancient cargo handling consisted almost exclusively of manually carrying cargo in ...
Mining under the sea is a challenging task in China. Affected by blasting, tunneling, and other engineering disturbance, surrounding rock is often in a state of cyclic loading and unloading stress. In this study, in order to investigate the effect of cyclic loading and unloading on the deformation and damage characteristics of sandstone underneath the Bohai Sea, the GCTS test machine is used ...
The size effect of coalgangue mass after loading and unloading test is the reflection of its inherent structural complexity, which is due to the existence of fracture network system in rock mass and the joint influence of loading and unloading process. Coalgangue physical and mechanical properties and particle distribution, as well as defects ...
In the process of coal formation, the internal structure is different from the occurrence of primary cracks. As a result, the new crack generation and primary crack development of different samples are affected to different degrees during loading and unloading. Energy characteristics under true triaxial loading and unloading
In this paper, the alternate loading and unloading by stages tests of raw coal samples were carried out by using the "Triaxial seepage test device of thermal fluid solid of coal and rock", the conclusions are as follows: The axial strain change rate ε 1 ′, the radial strain change rate ε 3 ′ and the permeability change rate k′ under unit stress state are used to represent the ...
Permeability changes with confining stress loadingunloading: (a) is the PUC; (b) is the cataclastic coal; (c) is the mylonitic coal; (d) is the loadingunloading process of confining stress. The increase in confining pressure compressed the coal matrix and internal fissures of the coal cores, and their permeability rapidly and then slowly ...
To investigate the influence of loadingunloading paths as well as loading and unloading rates on the deformation and failure behavior of coal, laboratory experiments and numerical simulations of unloading under axial pressure and confinement were carried out. The effect of different axial loading rates and unloading rates on the deformation and failure behavior of coal under the unloading ...
CAMTECH and RDSO to identify equipments which could be used for unloading coal ... During the process wagons are getting damaged due to following action of the ... Loading/unloading machines can be divided on the basis of dumping height and type of bucket. The equipment with a dumping height of about feet are called Dumpers or
Both coal mining and tunnel excavation exhibit significant unloading effects, with the process of confining pressure unloading causing damage to coal, thereby affecting coal impact characteristics and gas outburst characteristics. 1820 Based on their investigation, Ding et al. 21 performed a stability assessment study of deep mine dynamic ...
The rock mass in fault zones is frequently subjected to cyclic loading and unloading during deep resource exploitation and tunnel excavation. Research on the mechanical and hydraulic characteristics of fault rock during the cyclic loading and unloading is of great significance for revealing the formation mechanism of waterconducting pathways in fault and preventing water inrush disasters. In ...
Unloading PRB coal cars with a Dravo rotary dumper
Thus, the axial stress in the experiment is equal to the confining stress. In this study, three loading and unloading seepage tests have been carried out to simulate the effect of three coal seams mining on the caving zone and the second and third loading and unloading stress paths are the same as the first loading and unloading stress path.
In the cyclic loading and unloading process, the load ing and unloading elastic modulus of coal samples experi ences a rapid increase at the beginning stage of the cyclic
Fig. 3 presents the influences of gas pressure on coal permeability during gas loadingunloading processes at temperatures of 30 °C, 40 °C, 50 °C, 60 °C, and 70 °C, respectively. In the loading process, the coal permeability decreases gradually. As the pore pressure rises from MPa to MPa, the coal permeability decreases rapidly.
© DZCrusher - كل الحقوق محفوظة
